Canon imageRUNNER 1740iF E010 0001 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1740iF E010 0001 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1740iF E010 0001 Error Code
E010 0001
Description :
Main Motor (M2) rotation error
Causes :
Detection was performed every 100 msec since the start of drive and there had been no lock detection signal in 2 seconds.
Solutions :
1. Check the connector between the Main Motor and the DC Controller PCB (J203).
2. Replace the Main Motor (M2).
3. Replace the DC Controller PCB (PCB1).
Don’t forget, not every error is exactly identical. What fixes the malfunction one time may not eliminate it the next occasion. While the ideas in this writing is obtained from the service manual and usually ought to get your device operational, in some cases other causes may be in play.
If you are looking over this piece of content and have experience with this error message and desire to make a contribution please be sure to leave a comment beneath. Or, if you have read this article and have additional questions then ask. If I have knowledge about the trouble then I will reply.
