Canon imageRUNNER 1740iF E002 0000 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1740iF E002 0000 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1740iF E002 0000 Error Code
E002 0000
Description :
Error in temperature rising of Fixing Assembly
Causes :
1. The Main Thermistor detected a temperature lower than 115 deg C for 400 msec or longer on end 6.0 seconds after the Main Thermistor detected 100 deg C.
2. The Main Thermistor detected a temperature lower than 150 deg C for 400 msec or longer on end 6.0 seconds after the Main Thermistor detected 140 deg C.
Solutions :
1. Go through the following to clear the error: CLEAR > ENGIN > ERRCLR in Service Mode; then, turn OFF and then ON the power.
2. Check the connector connection. (J206 on the DC Controller PCB, J101 on the Power Supply PCB)
3. Replace the Fixing Assembly.
4. Replace the DC Controller PCB (PCB1).
Canon FM1-B701-000 Fuser (Fixing) Unit – 110 / 120 Volt (Genuine) – $279.95
from: Precision Roller
Canon imageRUNNER 1730 E000, E001, E002, E003, Error Code Reset
Canon imageRUNNER 1730 Fuser Removal and Replacement
Don’t forget, not every error is exactly alike. What fixes the problem one time might not fix it the next occasion. While the specifics in this blog post is obtained from the service manual and most likely should get your piece of equipment operating, on occasion other factors may be in play.
If you are looking over this page and have knowledge of this malfunction and wish to make a contribution make sure you leave a comment below. Or, if you have read this article and have more questions then ask. If I have information about the situation then I will answer.
