Canon imageRUNNER 1740iF E001 0002 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1740iF E001 0002 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1740iF E001 0002 Error Code
E001 0002
Description :
Detection of overheating of Fixing Assembly
Causes :
The Sub Thermistor detected 295 deg C or higher for 200msec or longer on end.
Solutions :
1. Go through the following to clear the error: CLEAR > ENGIN > ERRCLR in Service Mode; then, turn OFF and then ON the power.
2. Check the connector connection. (J206 on the DC Controller PCB, J101 on the Power Supply PCB)
3. Replace the Fixing Assembly.
4. Replace the DC Controller PCB (PCB1).
Canon FM1-B701-000 Fuser (Fixing) Unit – 110 / 120 Volt (Genuine) – $279.95
from: Precision Roller
Canon imageRUNNER 1730 E000, E001, E002, E003, Error Code Reset
Canon imageRUNNER 1730 Fuser Removal and Replacement
Don’t forget, not every error is entirely the same. What remedies the issue one time may possibly not take care of it the next occasion. While the details in this write-up is inspired by the service manual and most often ought to get your unit operational, occasionally additional circumstances can be in play.
If you are looking over this page and have knowledge of this fault and would wish to share please leave a comment below. Or, if you have read this article and have additional questions then ask. If I have knowledge about the difficulty then I will answer.
