Canon imageRUNNER 1740iF E001 0001 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1740iF E001 0001 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1740iF E001 0001 Error Code
E001 0001
Description :
Detection of overheating of Fixing Assembly
Causes :
The hardware circuit detected overheating of the Main Thermistor or Sub Thermistor for 30 msec or longer.
Solutions :
1. Go through the following to clear the error: CLEAR > ENGIN > ERRCLR in Service Mode; then, turn OFF and then ON the power.
2. Replace the DC Controller PCB (PCB1).
Don’t forget, not every error is entirely the same. What corrects the problem one time may not take care of it the next occasion. While the details in this document is inspired by the service manual and oftentimes should get your unit operating, at times additional variables could possibly be in play.
If you are looking over this page and have knowledge about this malfunction and would like to share make sure you leave a comment underneath. Or, if you have read this article and have more questions then ask. If I have information about the trouble then I will respond.
