Canon imageRUNNER 1740 E822 0003 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1740 E822 0003 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1740 E822 0003 Error Code
E822 0003
Description :
Error in rotation of the Delivery Cooling Fan (Center) (FM2)
Causes :
A lock signal was detected for 5 seconds while the Delivery Cooling Fan (Center) (FM2) was being driven.
The same status was detected again after executing an error retry.
Solutions :
1. Disconnect and then connect the connector (J210) on the DC Controller PCB (PCB1) to check the connection.
2. Replace the Delivery Cooling Fan (Center) (FM2).
3. Replace the DC Controller PCB (PCB1).
Don’t forget, not every error is entirely alike. What treats the issue one occasion may not resolve it the next time. While the ideas in this short article comes from the service manual and most likely ought to get your equipment working, from time to time additional variables may be in play.
If you are looking over this page and have exposure to this malfunction and would like to make a contribution please make sure to leave a comment down the page. Or, if you have read this article and have additional questions then ask. If I have information about the difficulty then I will answer.
