Canon imageRUNNER 1740 E822 0002 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1740 E822 0002 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1740 E822 0002 Error Code
E822 0002
Description :
Delivery Cooling Fan (Center) (FM2) error
Causes :
A lock signal was detected for 5 seconds while the Delivery Cooling Fan (Center) (FM2) was being driven.
The same status was detected again after executing an error retry.
Solutions :
1. Disconnect and then connect the connector (J210) on the DC Controller PCB (PCB1) to check the connection.
2. Replace the Delivery Cooling Fan (Center) (FM2).
3. Replace the DC Controller PCB (PCB1).
Don’t forget, not every error is entirely alike. What remedies the trouble one time may possibly not take care of it the next time. While the content in this document is obtained from the service manual and oftentimes should get your piece of equipment working, at times additional circumstances may be in play.
If you are looking over this page and have exposure to this fault and would wish to share please be sure to leave a comment down the page. Or, if you have read this article and have more questions then ask. If I have knowledge about the trouble then I will reply.
