Canon imageRUNNER 1740 E820 0003 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1740 E820 0003 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1740 E820 0003 Error Code
E820 0003
Description :
Error in rotation of the Developing Cooling Fan (Rear) (FM8)
Causes :
A lock signal was detected for 5 seconds while the Developing Cooling Fan (Rear) (FM8) was being driven.
The same status was detected again after executing an error retry.
Solutions :
1. Disconnect and then connect the connector (J209) on the DC Controller PCB (PCB1) to check the connection.
2. Replace the Developing Cooling Fan (Rear) (FM8).
3. Replace the DC Controller PCB (PCB1).
Don’t forget, not every error is completely the same. What remedies the condition one time might not get rid of it the next occasion. While the info in this piece of content is taken from the service manual and typically ought to get your piece of equipment ready to go, from time to time other things may be in play.
If you are looking over this page and have expertise in this error and wish to contribute make sure you leave a comment beneath. Or, if you have read this article and have further questions then ask. If I have information about the situation then I will reply.
