Canon imageRUNNER 1740 E805 0002 Error Code

 

Canon imageRUNNER 1740 E805 0002 Error Code Instructions

Below you will find the service manual information for the Canon imageRUNNER 1740 E805 0002 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it. 

Canon imageRUNNER 1740 E805 0002 Error Code

Service Manual Instructions for the Canon imageRUNNER 1740 E805 0002 Error Code

E805 0002
Description :
Heat Exhaust Fan (Front) (FM5) error

Causes :
A lock signal was detected for 5 seconds while the Heat Exhaust Fan (Front) (FM5) was being stopped.
The same status was detected again after executing an error retry.

Solutions :
1. Disconnect and then connect the connector (J212) on the DC Controller PCB (PCB1) to check the connection.
2. Replace the Heat Exhaust Fan (Front) (FM5).
3. Replace the DC Controller PCB (PCB1).



Don’t forget, not every error is completely identical. What remedies the problem one occasion might not resolve it the next occasion. While the content in this blog post derives from the service manual and oftentimes should get your product operating, sometimes other factors can be in play.

If you are looking over this document and have knowledge of this malfunction and would wish to contribute please be sure to leave a comment down below. Or, if you have read this article and have additional questions then ask. If I have information about the situation then I will reply.

We will be happy to hear your thoughts

Leave a reply

Shopping cart