Canon imageRUNNER 1740 E805 0001 Error Code

 

Canon imageRUNNER 1740 E805 0001 Error Code Instructions

Below you will find the service manual information for the Canon imageRUNNER 1740 E805 0001 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it. 

Canon imageRUNNER 1740 E805 0001 Error Code

Service Manual Instructions for the Canon imageRUNNER 1740 E805 0001 Error Code

E805 0001
Description :
Error in rotation of the Heat Exhaust Fan (Rear) (FM6)

Causes :
A lock signal could not be detected for 5 seconds while the Heat Exhaust Fan (Rear) (FM6) was being driven.
The same status was detected again after executing an error retry.

Solutions :
1. Disconnect and then connect the connector (J212) on the DC Controller PCB (PCB1) to check the connection.
2. Replace the Heat Exhaust Fan (Rear) (FM6).
3. Replace the DC Controller PCB (PCB1).



Don’t forget, not every error is completely identical. What fixes the malfunction one time may not fix it the next occasion. While the tips in this short article hails from the service manual and oftentimes should get your device operational, in some cases other variables could possibly be in play.

If you are looking over this document and have knowledge of this fault and wish to make a contribution please be sure to leave a comment beneath. Or, if you have read this article and have more questions then ask. If I have knowledge about the problem then I will reply.

We will be happy to hear your thoughts

Leave a reply

Shopping cart