Canon imageRUNNER 1740 E805 0000 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1740 E805 0000 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1740 E805 0000 Error Code
E805 0000
Description :
Heat Exhaust Fan (Rear) (FM6) error
Causes :
A lock signal was detected for 5 seconds while the Heat Exhaust Fan (Rear) (FM6) was being stopped.
The same status was detected again after executing an error retry.
Solutions :
1. Disconnect and then connect the connector (J212) on the DC Controller PCB (PCB1) to check the connection.
2. Replace the Heat Exhaust Fan (Rear) (FM6).
3. Replace the DC Controller PCB (PCB1).
Don’t forget, not every error is completely identical. What corrects the trouble one time might not remedy it the next time. While the specifics in this post comes from the service manual and generally should get your unit working, now and again other variables could possibly be in play.
If you are looking over this document and have knowledge of this error message and would wish to contribute please make sure to leave a comment down below. Or, if you have read this article and have further questions then ask. If I have knowledge about the situation then I will answer back.
