Canon imageRUNNER 1740 E537 8002 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1740 E537 8002 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1740 E537 8002 Error Code
E537 8002
Description :
Rear Alignment Motor (M5) error
Causes :
At initialization of the Rear Alignment Plate, the Rear Alignment Plate failed to be detected by the Rear Alignment Plate HP Sensor (S5) although the Rear Alignment Motor (M5) was driven for 0.78sec.
Solutions :
1. Check the connector connection of the Rear Alignment Plate HP Sensor (S5) or the Rear Alignment Motor (M5).
2. Check for open circuit of the Harness of the Rear Alignment Plate HP Sensor (S5) or the Rear Alignment Motor (M5).
3. Replace the Rear Alignment Plate HP Sensor (S5).
4. Replace the Rear Alignment Motor (M5).
5. Replace the Finisher Controller PCB.
Don’t forget, not every error is absolutely alike. What fixes the issue one occasion may possibly not solve it the next time. While the content in this article is inspired by the service manual and generally ought to get your machine operating, at times additional circumstances may be in play.
If you are looking over this document and have expertise in this fault and desire to share be sure to leave a comment beneath. Or, if you have read this article and have additional questions then ask. If I have information about the trouble then I will respond.
