Canon imageRUNNER 1740 E531 8002 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1740 E531 8002 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1740 E531 8002 Error Code
E531 8002
Description :
Staple Motor (M9) error
Causes :
After execution of staple operation, the motor was operated in the positive direction, but the Staple Unit could not be detected by the Staple HP Sensor (S11) within 0.46 seconds. Then, the motor was rotated in the negative direction, but the Staple Unit could not be detected by the Staple HP Sensor (S11) within 0.46sec.
Solutions :
1. Check the connector connection of the Staple Unit.
2. Disconnect the Harness of the Staple Unit.
3. Replace the Staple Unit.
4. Replace the Finisher Controller PCB.
Do not forget, not every error is totally the same. What fixes the trouble one time may possibly not fix it the next time. While the information in this write-up is taken from the service manual and generally ought to get your device ready to go, occasionally additional variables might be in play.
If you are looking over this document and have expertise in this error and want to contribute please make sure to leave a comment underneath. Or, if you have read this article and have additional questions then ask. If I have information about the problem then I will reply.
