Canon imageRUNNER 1740 E531 8001 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1740 E531 8001 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1740 E531 8001 Error Code
E531 8001
Description :
Staple Motor (M9) error
Causes :
The Stapler failed to move from the Staple HP Sensor (S11) within the staple execution time (0.45sec).
Solutions :
1. Check the connector connection of the Staple Unit.
2. Check for open circuit of the Harness of the Staple Unit.
3. Replace the Staple Unit.
4. Replace the Finisher Controller PCB.
Do not forget, not every error is totally the same. What fixes the complication one occasion may possibly not eliminate it the next occasion. While the content in this document derives from the service manual and typically should get your unit operational, at times other variables can be in play.
If you are looking over this document and have experience with this problem and wish to contribute make sure you leave a comment underneath. Or, if you have read this article and have additional questions then ask. If I have exposure to the issue then I will reply.
