Canon imageRUNNER 1740 E530 8002 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1740 E530 8002 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1740 E530 8002 Error Code
E530 8002
Description :
Front Alignment Motor (M4) error
Causes :
At initialization of the Front Alignment Plate, the Front Alignment Plate failed to be detected by the Front Alignment Plate HP Sensor (S4) although the Front Alignment Motor (M4) was driven for 0.78 seconds.
Solutions :
1. Check the connector connection of the Front Alignment Plate HP Sensor (S4) or the Front Alignment Motor (M4).
2. Check for open circuit of the Harness of the Front Alignment Plate HP Sensor (S4) or the Front Alignment Motor (M4).
3. Replace the Front Alignment Plate HP Sensor (S4).
4. Replace the Front Alignment Motor (M4).
5. Replace the Finisher Controller PCB.
Do not forget, not every error is totally identical. What treats the issue one time might not take care of it the next time. While the data in this document originates from the service manual and normally should get your machine operational, now and again other factors could possibly be in play.
If you are looking over this document and have experience with this problem and desire to share make sure you leave a comment beneath. Or, if you have read this article and have additional questions then ask. If I have exposure to the issue then I will reply.
