Canon imageRUNNER 1740 E261 0000 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1740 E261 0000 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1740 E261 0000 Error Code
E261 0000
Description :
Zero cross signal error
Causes :
When the relay is ON, the zero cross signal failed to be detected for 500 msec or longer.
When the same status was detected again after executing an error retry.
Solutions :
1. Check the connector connection. (All connectors on the DC Controller PCB)
2. Replace the DC Controller PCB (PCB1).
Do not forget, not every error is simply identical. What corrects the complication one time may not take care of it the next time. While the info in this posting originates from the service manual and normally should get your equipment working, sometimes other causes can be in play.
If you are looking over this article and have knowledge of this malfunction and would like to contribute please make sure to leave a comment down the page. Or, if you have read this article and have further questions then ask. If I have knowledge about the issue then I will reply.
