Canon imageRUNNER 1740 E110 0003 Error Code

 

Canon imageRUNNER 1740 E110 0003 Error Code Instructions

Below you will find the service manual information for the Canon imageRUNNER 1740 E110 0003 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it. 

Canon imageRUNNER 1740 E110 0003 Error Code

Service Manual Instructions for the Canon imageRUNNER 1740 E110 0003 Error Code

E110 0003
Description :
Laser Scanner Motor error

Causes :
The speed lock signal of the Laser Scanner Motor never showed lock status although 6.5 seconds (when switching from low speed to normal speed) or 8 seconds (when switching from normal speed to low speed) have passed.
When the same status was detected again after executing an error retry.

Solutions :
1. Check the Laser Scanner Unit connector.
2. Replace the Laser Scanner Unit.
3. Replace the DC Controller PCB (PCB1).



Do not forget, not every error is exactly the same. What remedies the complication one time might not resolve it the next time. While the data in this write-up is obtained from the service manual and usually should get your device operating, occasionally additional factors could possibly be in play.

If you are looking over this article and have information about this error message and desire to contribute please make sure to leave a comment down the page. Or, if you have read this article and have further questions then ask. If I have exposure to the issue then I will reply.

We will be happy to hear your thoughts

Leave a reply

Shopping cart