Canon imageRUNNER 1740 E010 0002 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1740 E010 0002 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1740 E010 0002 Error Code
E010 0002
Description :
Main Motor (M2) rotation error
Causes :
Detection was performed every 100msec during the drive (after the lock detection) and the lock signal was not detected 5 times in a row (in 500 msec).
Solutions :
1. Check the connector between the Main Motor and the DC Controller PCB (J203).
2. Replace the Main Motor (M2).
3. Replace the DC Controller PCB (PCB1).
Do not forget, not every error is entirely alike. What fixes the issue one occasion will possibly not resolve it the next occasion. While the information in this piece of content is obtained from the service manual and oftentimes should get your equipment operational, sometimes other reasons could possibly be in play.
If you are looking at this write-up and have knowledge of this error message and would wish to contribute make sure you leave a comment beneath. Or, if you have read this article and have additional questions then ask. If I have experience with the trouble then I will respond.
