Canon imageRUNNER 1740 E010 0001 Error Code

 

Canon imageRUNNER 1740 E010 0001 Error Code Instructions

Below you will find the service manual information for the Canon imageRUNNER 1740 E010 0001 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it. 

Canon imageRUNNER 1740 E010 0001 Error Code

Service Manual Instructions for the Canon imageRUNNER 1740 E010 0001 Error Code

E010 0001
Description :
Main Motor (M2) rotation error

Causes :
Detection was performed every 100 msec since the start of drive and there had been no lock detection signal in 2 seconds.

Solutions :
1. Check the connector between the Main Motor and the DC Controller PCB (J203).
2. Replace the Main Motor (M2).
3. Replace the DC Controller PCB (PCB1).



Do not forget, not every error is entirely alike. What corrects the malfunction one time will possibly not get rid of it the next time. While the material in this written piece originates from the service manual and most often should get your product ready to go, from time to time additional circumstances might be in play.

If you are looking at this write-up and have knowledge of this error and would like to share please make sure to leave a comment below. Or, if you have read this article and have more questions then ask. If I have information about the situation then I will reply.

We will be happy to hear your thoughts

Leave a reply

Shopping cart