Canon imageRUNNER 1740 E002 0000 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1740 E002 0000 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1740 E002 0000 Error Code
E002 0000
Description :
Error in temperature rising of Fixing Assembly
Causes :
1. The Main Thermistor detected a temperature lower than 115 deg C for 400 msec or longer on end 6.0 seconds after the Main Thermistor detected 100 deg C.
2. The Main Thermistor detected a temperature lower than 150 deg C for 400 msec or longer on end 6.0 seconds after the Main Thermistor detected 140 deg C.
Solutions :
1. Go through the following to clear the error: CLEAR > ENGIN > ERRCLR in Service Mode; then, turn OFF and then ON the power.
2. Check the connector connection. (J206 on the DC Controller PCB, J101 on the Power Supply PCB)
3. Replace the Fixing Assembly.
4. Replace the DC Controller PCB (PCB1).
Canon FM1-B701-000 Fuser (Fixing) Unit – 110 / 120 Volt (Genuine) – $279.95
from: Precision Roller
Canon imageRUNNER 1730 E000, E001, E002, E003, Error Code Reset
Canon imageRUNNER 1730 Fuser Removal and Replacement
Do not forget, not every error is completely identical. What treats the malfunction one occasion might not exactly remedy it the next occasion. While the information in this text hails from the service manual and typically should get your product ready to go, on occasion other causes might be in play.
If you are looking at this write-up and have knowledge about this error message and would like to contribute make sure you leave a comment beneath. Or, if you have read this article and have more questions then ask. If I have experience with the issue then I will answer back.
