Canon imageRUNNER 1740 E001 0002 Error Code

 

Canon imageRUNNER 1740 E001 0002 Error Code Instructions

Below you will find the service manual information for the Canon imageRUNNER 1740 E001 0002 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it. 

Canon imageRUNNER 1740 E001 0002 Error Code

Service Manual Instructions for the Canon imageRUNNER 1740 E001 0002 Error Code

E001 0002
Description :
Detection of overheating of Fixing Assembly

Causes :
The Sub Thermistor detected 295 deg C or higher for 200msec or longer on end.

Solutions :
1. Go through the following to clear the error: CLEAR > ENGIN > ERRCLR in Service Mode; then, turn OFF and then ON the power.
2. Check the connector connection. (J206 on the DC Controller PCB, J101 on the Power Supply PCB)
3. Replace the Fixing Assembly.
4. Replace the DC Controller PCB (PCB1).


Canon FM1-B701-000 Fuser (Fixing) Unit – 110 / 120 Volt (Genuine) – $279.95

from: Precision Roller

Canon imageRUNNER 1730 E000, E001, E002, E003, Error Code Reset


Canon imageRUNNER 1730 Fuser Removal and Replacement

Do not forget, not every error is completely identical. What treats the condition one time might not exactly fix it the next time. While the ideas in this short article hails from the service manual and most often ought to get your product up and running, in some cases other elements might be in play.

If you are looking at this write-up and have knowledge about this error message and desire to contribute please leave a comment beneath. Or, if you have read this article and have further questions then ask. If I have information about the difficulty then I will reply.

We will be happy to hear your thoughts

Leave a reply

Shopping cart