Canon imageRUNNER 1730iF E822 0004 Error Code

 

Canon imageRUNNER 1730iF E822 0004 Error Code Instructions

Below you will find the service manual information for the Canon imageRUNNER 1730iF E822 0004 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it. 

Canon imageRUNNER 1730iF E822 0004 Error Code

Service Manual Instructions for the Canon imageRUNNER 1730iF E822 0004 Error Code

E822 0004
Description :
Delivery Cooling Fan (Rear) (FM1) error

Causes :
A lock signal was detected for 5 seconds while the Delivery Cooling Fan (Rear) (FM1) was being driven.
The same status was detected again after executing an error retry.

Solutions :
1. Disconnect and then connect the connector (J210) on the DC Controller PCB (PCB1) to check the connection.
2. Replace the Delivery Cooling Fan (Rear) (FM1).
3. Replace the DC Controller PCB (PCB1).



Do not forget, not every error is completely identical. What corrects the situation one occasion may not solve it the next occasion. While the content in this write-up comes from the service manual and most often should get your device up and running, now and again other elements can be in play.

If you are looking at this write-up and have information about this fault and would like to make a contribution please make sure to leave a comment underneath. Or, if you have read this article and have additional questions then ask. If I have exposure to the situation then I will answer back.

We will be happy to hear your thoughts

Leave a reply

Shopping cart