Canon imageRUNNER 1730iF E822 0003 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1730iF E822 0003 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1730iF E822 0003 Error Code
E822 0003
Description :
Error in rotation of the Delivery Cooling Fan (Center) (FM2)
Causes :
A lock signal was detected for 5 seconds while the Delivery Cooling Fan (Center) (FM2) was being driven.
The same status was detected again after executing an error retry.
Solutions :
1. Disconnect and then connect the connector (J210) on the DC Controller PCB (PCB1) to check the connection.
2. Replace the Delivery Cooling Fan (Center) (FM2).
3. Replace the DC Controller PCB (PCB1).
Do not forget, not every error is completely identical. What corrects the problem one occasion might not exactly eliminate it the next time. While the info in this document comes from the service manual and usually ought to get your piece of equipment working, in some cases additional factors could possibly be in play.
If you are looking at this write-up and have information about this error message and want to contribute please be sure to leave a comment down the page. Or, if you have read this article and have additional questions then ask. If I have experience with the difficulty then I will answer back.
