Canon imageRUNNER 1730iF E822 0001 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1730iF E822 0001 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1730iF E822 0001 Error Code
E822 0001
Description :
Error in rotation of the Delivery Cooling Fan (Front) (FM3)
Causes :
A lock signal was detected for 5 seconds while the Delivery Cooling Fan (Front) (FM3) was being driven.
The same status was detected again after executing an error retry.
Solutions :
1. Disconnect and then connect the connector (J210) on the DC Controller PCB (PCB1) to check the connection.
2. Replace the Delivery Cooling Fan (Front) (FM3).
3. Replace the DC Controller PCB (PCB1).
Do not forget, not every error is completely alike. What remedies the issue one time may not remedy it the next occasion. While the tips in this page obtain from the service manual and typically should get your machine operational, at times other variables might be in play.
If you are looking at this write-up and have exposure to this error message and desire to share make sure you leave a comment underneath. Or, if you have read this article and have more questions then ask. If I have knowledge about the difficulty then I will answer.
