Canon imageRUNNER 1730iF E820 0002 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1730iF E820 0002 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1730iF E820 0002 Error Code
E820 0002
Description :
Developing Cooling Fan (Rear) (FM8) error
Causes :
A lock signal was detected for 5 seconds while the Developing Cooling Fan (Rear) (FM8) was being stopped.
The same status was detected again after executing an error retry.
Solutions :
1. Disconnect and then connect the connector (J209) on the DC Controller PCB (PCB1) to check the connection.
2. Replace the Developing Cooling Fan (Rear) (FM8).
3. Replace the DC Controller PCB (PCB1).
Do not forget, not every error is absolutely identical. What treats the issue one time might not remedy it the next occasion. While the info in this short article originates from the service manual and most likely should get your unit up and running, now and again other reasons may be in play.
If you are looking at this write-up and have experience with this error and would wish to contribute you should leave a comment beneath. Or, if you have read this article and have additional questions then ask. If I have experience with the situation then I will answer.
