Canon imageRUNNER 1730iF E575 8002 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1730iF E575 8002 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1730iF E575 8002 Error Code
E575 8002
Description :
Gripper Motor (M7) error
Causes :
The gripper unit does not leave the gripper unit home position when the Gripper Motor (M7) has been driven for 3.8 seconds.
Solutions :
1. Check the connector connection of the Gripper HP Sensor (S7) or the Gripper Motor (M7).
2. Check for open circuit of the Harness of the Gripper HP Sensor (S7) or the Gripper Motor (M7).
3. Replace the Gripper HP Sensor (S7).
4. Replace the Gripper Motor (M7).
5. Replace the Finisher Controller PCB.
Bear in mind, not every error is precisely the same. What treats the malfunction one occasion may possibly not resolve it the next time. While the specifics in this piece of content is taken from the service manual and usually should get your machine working, occasionally additional circumstances may be in play.
If you are looking at this short article and have experience with this problem and would wish to make a contribution please leave a comment underneath. Or, if you have read this article and have further questions then ask. If I have knowledge about the issue then I will answer.
