Canon imageRUNNER 1730iF E540 8001 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1730iF E540 8001 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1730iF E540 8001 Error Code
E540 8001
Description :
Stack Tray Shift Motor (M8) error
Causes :
The Stack Tray Shift Motor (M8) was driven for 4 seconds, but the Stack Tray shifting operation could not be completed.
Solutions :
1. Check the connector connection of the Stack Tray Paper Height Sensor (S9) or the Stack Tray Shift Motor (M8).
2. Check for open circuit of the Harness of the Stack Tray Paper Height Sensor (S9) or the Stack Tray Shift Motor (M8).
3. Replace the Stack Tray Paper Height Sensor (S9).
4. Replace the Stack Tray Shift Motor (M8).
5. Replace the Finisher Controller PCB.
Bear in mind, not every error is precisely the same. What corrects the problem one occasion may not take care of it the next occasion. While the specifics in this writing is taken from the service manual and normally should get your equipment functioning, in some cases additional variables may be in play.
If you are looking at this short article and have experience with this error and want to share please be sure to leave a comment below. Or, if you have read this article and have further questions then ask. If I have information about the problem then I will answer back.
