Canon imageRUNNER 1730iF E537 8001 Error Code

 

Canon imageRUNNER 1730iF E537 8001 Error Code Instructions

Below you will find the service manual information for the Canon imageRUNNER 1730iF E537 8001 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it. 

Canon imageRUNNER 1730iF E537 8001 Error Code

Service Manual Instructions for the Canon imageRUNNER 1730iF E537 8001 Error Code

E537 8001
Description :
Rear Alignment Motor (M5) error

Causes :
At initialization of the Rear Alignment Plate, the Rear Alignment Plate failed to move from the Rear Alignment Plate HP Sensor (S5) although the Rear Alignment Motor (M5) was driven for 10 mm.

Solutions :
1. Check the connector connection of the Rear Alignment Plate HP Sensor (S5) or the Rear Alignment Motor (M5).
2. Check for open circuit of the Harness of the Rear Alignment Plate HP Sensor (S5) or the Rear Alignment Motor (M5).
3. Replace the Rear Alignment Plate HP Sensor (S5).
4. Replace the Rear Alignment Motor (M5).
5. Replace the Finisher Controller PCB.


Bear in mind, not every error is precisely the same. What corrects the complication one occasion may possibly not take care of it the next time. While the tips in this page is inspired by the service manual and in most cases should get your equipment working, in some cases other things may be in play.

If you are looking at this post and have knowledge of this problem and would wish to share make sure you leave a comment underneath. Or, if you have read this article and have additional questions then ask. If I have experience with the situation then I will respond.

We will be happy to hear your thoughts

Leave a reply

Shopping cart