Canon imageRUNNER 1730iF E531 8002 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1730iF E531 8002 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1730iF E531 8002 Error Code
E531 8002
Description :
Staple Motor (M9) error
Causes :
After execution of staple operation, the motor was operated in the positive direction, but the Staple Unit could not be detected by the Staple HP Sensor (S11) within 0.46 seconds. Then, the motor was rotated in the negative direction, but the Staple Unit could not be detected by the Staple HP Sensor (S11) within 0.46sec.
Solutions :
1. Check the connector connection of the Staple Unit.
2. Disconnect the Harness of the Staple Unit.
3. Replace the Staple Unit.
4. Replace the Finisher Controller PCB.
Bear in mind, not every error is precisely identical. What treats the malfunction one time will possibly not solve it the next occasion. While the details in this blog post originates from the service manual and normally ought to get your equipment operational, now and again other elements can be in play.
If you are looking at this post and have knowledge of this malfunction and want to share please be sure to leave a comment down the page. Or, if you have read this article and have more questions then ask. If I have exposure to the difficulty then I will answer.
