Canon imageRUNNER 1730iF E530 8002 Error Code

 

Canon imageRUNNER 1730iF E530 8002 Error Code Instructions

Below you will find the service manual information for the Canon imageRUNNER 1730iF E530 8002 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it. 

Canon imageRUNNER 1730iF E530 8002 Error Code

Service Manual Instructions for the Canon imageRUNNER 1730iF E530 8002 Error Code

E530 8002
Description :
Front Alignment Motor (M4) error

Causes :
At initialization of the Front Alignment Plate, the Front Alignment Plate failed to be detected by the Front Alignment Plate HP Sensor (S4) although the Front Alignment Motor (M4) was driven for 0.78 seconds.

Solutions :
1. Check the connector connection of the Front Alignment Plate HP Sensor (S4) or the Front Alignment Motor (M4).
2. Check for open circuit of the Harness of the Front Alignment Plate HP Sensor (S4) or the Front Alignment Motor (M4).
3. Replace the Front Alignment Plate HP Sensor (S4).
4. Replace the Front Alignment Motor (M4).
5. Replace the Finisher Controller PCB.


Bear in mind, not every error is precisely alike. What treats the trouble one time might not fix it the next occasion. While the advice in this written piece is obtained from the service manual and most often ought to get your device operating, occasionally other factors might be in play.

If you are looking at this post and have knowledge of this error message and want to make a contribution you should leave a comment below. Or, if you have read this article and have additional questions then ask. If I have knowledge about the difficulty then I will answer back.

We will be happy to hear your thoughts

Leave a reply

Shopping cart