Canon imageRUNNER 1730iF E010 0002 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1730iF E010 0002 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1730iF E010 0002 Error Code
E010 0002
Description :
Main Motor (M2) rotation error
Causes :
Detection was performed every 100msec during the drive (after the lock detection) and the lock signal was not detected 5 times in a row (in 500 msec).
Solutions :
1. Check the connector between the Main Motor and the DC Controller PCB (J203).
2. Replace the Main Motor (M2).
3. Replace the DC Controller PCB (PCB1).
Bear in mind, not every error is absolutely identical. What fixes the condition one time may not fix it the next time. While the data in this blog post originates from the service manual and normally should get your piece of equipment operating, at times additional factors may be in play.
If you are looking at this piece of content and have expertise in this malfunction and would wish to contribute please make sure to leave a comment below. Or, if you have read this article and have more questions then ask. If I have knowledge about the situation then I will answer.
