Canon imageRUNNER 1730iF E003 0000 Error Code

 

Canon imageRUNNER 1730iF E003 0000 Error Code Instructions

Below you will find the service manual information for the Canon imageRUNNER 1730iF E003 0000 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it. 

Canon imageRUNNER 1730iF E003 0000 Error Code

Service Manual Instructions for the Canon imageRUNNER 1730iF E003 0000 Error Code

E003 0000
Description :
Detection of fixing low temperature during printing

Causes :
The Main Thermistor detected a temperature lower than 80 deg C for 200 msec or longer on end, or the Sub Thermistor detected a temperature lower than 60 deg C for 200 msec or longer on end.

Solutions :
1. Go through the following to clear the error: CLEAR > ENGIN > ERRCLR in Service Mode; then, turn OFF and then ON the power.
2. Check the connector connection. (J206 on the DC Controller PCB, J101 on the Power Supply PCB)
3. Replace the Fixing Assembly.
4. Replace the DC Controller PCB (PCB1).


Canon FM1-B701-000 Fuser (Fixing) Unit – 110 / 120 Volt (Genuine) – $279.95

from: Precision Roller

Canon imageRUNNER 1730 E000, E001, E002, E003, Error Code Reset


Canon imageRUNNER 1730 Fuser Removal and Replacement

Bear in mind, not every error is absolutely alike. What remedies the complication one time might not exactly solve it the next time. While the tips in this write-up is taken from the service manual and most likely should get your machine ready to go, on occasion other variables might be in play.

If you are looking at this piece of content and have expertise in this error message and want to contribute please make sure to leave a comment down below. Or, if you have read this article and have further questions then ask. If I have experience with the trouble then I will answer back.

We will be happy to hear your thoughts

Leave a reply

Shopping cart