Canon imageRUNNER 1730 E822 0005 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1730 E822 0005 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1730 E822 0005 Error Code
E822 0005
Description :
Error in rotation of the Delivery Cooling Fan (Rear) (FM1)
Causes :
A lock signal was detected for 5 seconds while the Delivery Cooling Fan (Rear) (FM1) was being driven.
The same status was detected again after executing an error retry.
Solutions :
1. Disconnect and then connect the connector (J210) on the DC Controller PCB (PCB1) to check the connection.
2. Replace the Delivery Cooling Fan (Rear) (FM1).
3. Replace the DC Controller PCB (PCB1).
Always remember, not every error is totally the same. What treats the issue one occasion may not solve it the next time. While the content in this written piece obtain from the service manual and usually ought to get your device up and running, occasionally other things might be in play.
If you are looking at this piece of content and have experience with this error and would like to share you should leave a comment down below. Or, if you have read this article and have further questions then ask. If I have knowledge about the situation then I will reply.
