Canon imageRUNNER 1730 E822 0002 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1730 E822 0002 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1730 E822 0002 Error Code
E822 0002
Description :
Delivery Cooling Fan (Center) (FM2) error
Causes :
A lock signal was detected for 5 seconds while the Delivery Cooling Fan (Center) (FM2) was being driven.
The same status was detected again after executing an error retry.
Solutions :
1. Disconnect and then connect the connector (J210) on the DC Controller PCB (PCB1) to check the connection.
2. Replace the Delivery Cooling Fan (Center) (FM2).
3. Replace the DC Controller PCB (PCB1).
Always remember, not every error is totally the same. What fixes the issue one occasion may not take care of it the next occasion. While the advice in this short article obtain from the service manual and most often ought to get your piece of equipment working, on occasion other reasons might be in play.
If you are looking at this page and have knowledge about this error and want to contribute please make sure to leave a comment underneath. Or, if you have read this article and have additional questions then ask. If I have knowledge about the difficulty then I will answer.
