Canon imageRUNNER 1730 E822 0000 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1730 E822 0000 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1730 E822 0000 Error Code
E822 0000
Description :
Delivery Cooling Fan (Front) (FM3) error
Causes :
A lock signal was detected for 5 seconds while the Delivery Cooling Fan (Front) (FM3) was being driven.
The same status was detected again after executing an error retry.
Solutions :
1. Disconnect and then connect the connector (J210) on the DC Controller PCB (PCB1) to check the connection.
2. Replace the Delivery Cooling Fan (Front) (FM3).
3. Replace the DC Controller PCB (PCB1).
Always remember, not every error is totally identical. What treats the trouble one occasion will possibly not eliminate it the next occasion. While the tips in this text derives from the service manual and most likely should get your unit functioning, occasionally additional variables can be in play.
If you are looking at this page and have information about this error and wish to make a contribution please make sure to leave a comment down the page. Or, if you have read this article and have further questions then ask. If I have exposure to the difficulty then I will respond.
