Canon imageRUNNER 1730 E820 0003 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1730 E820 0003 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1730 E820 0003 Error Code
E820 0003
Description :
Error in rotation of the Developing Cooling Fan (Rear) (FM8)
Causes :
A lock signal was detected for 5 seconds while the Developing Cooling Fan (Rear) (FM8) was being driven.
The same status was detected again after executing an error retry.
Solutions :
1. Disconnect and then connect the connector (J209) on the DC Controller PCB (PCB1) to check the connection.
2. Replace the Developing Cooling Fan (Rear) (FM8).
3. Replace the DC Controller PCB (PCB1).
Always remember, not every error is totally identical. What treats the complication one occasion may possibly not get rid of it the next occasion. While the info in this posting is obtained from the service manual and in most cases ought to get your device operational, now and again other factors might be in play.
If you are looking at this page and have exposure to this problem and want to make a contribution please make sure to leave a comment down the page. Or, if you have read this article and have further questions then ask. If I have knowledge about the issue then I will respond.
