Canon imageRUNNER 1730 E820 0001 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1730 E820 0001 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1730 E820 0001 Error Code
E820 0001
Description :
Error in rotation of the Developing Cooling Fan (Front) (FM7)
Causes :
A lock signal could not be detected for 5 seconds while the Developing Cooling Fan (Front) (FM7) was being driven.
The same status was detected again after executing an error retry.
Solutions :
1. Disconnect and then connect the connector (J209) on the DC Controller PCB (PCB1) to check the connection.
2. Replace the Developing Cooling Fan (Front) (FM7).
3. Replace the DC Controller PCB (PCB1).
Always remember, not every error is totally identical. What fixes the difficulty one time might not eliminate it the next occasion. While the details in this blog is inspired by the service manual and normally should get your unit operational, now and again additional variables may be in play.
If you are looking at this page and have exposure to this fault and want to make a contribution please make sure to leave a comment below. Or, if you have read this article and have additional questions then ask. If I have information about the trouble then I will answer back.
