Canon imageRUNNER 1730 E820 0000 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1730 E820 0000 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1730 E820 0000 Error Code
E820 0000
Description :
Developing Cooling Fan (Front) (FM7) error
Causes :
A lock signal was detected for 5 seconds while the Developing Cooling Fan (Front) (FM7) was being driven.
The same status was detected again after executing an error retry.
Solutions :
1. Disconnect and then connect the connector (J209) on the DC Controller PCB (PCB1) to check the connection.
2. Replace the Developing Cooling Fan (Front) (FM7).
3. Replace the DC Controller PCB (PCB1).
Always remember, not every error is totally identical. What corrects the malfunction one time will possibly not get rid of it the next time. While the data in this page is taken from the service manual and generally ought to get your product up and running, at times additional variables may be in play.
If you are looking at this page and have exposure to this error message and wish to make a contribution please make sure to leave a comment underneath. Or, if you have read this article and have additional questions then ask. If I have experience with the trouble then I will answer back.
