Canon imageRUNNER 1730 E804 0000 Error Code

 

Canon imageRUNNER 1730 E804 0000 Error Code Instructions

Below you will find the service manual information for the Canon imageRUNNER 1730 E804 0000 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it. 

Canon imageRUNNER 1730 E804 0000 Error Code

Service Manual Instructions for the Canon imageRUNNER 1730 E804 0000 Error Code

E804 0000
Description :
Power Supply Cooling Fan (FM4) error

Causes :
A lock signal was detected for 5 seconds while the Power Supply Cooling Fan (FM4) was being stopped.
The same status was detected again after executing an error retry.

Solutions :
1. Disconnect and then connect the connector (J209) on the DC Controller PCB (PCB1) to check the connection.
2. Replace the Power Supply Cooling Fan (FM4).
3. Replace the DC Controller PCB (PCB1).



Always remember, not every error is simply the same. What treats the problem one time might not fix it the next occasion. While the help and advice in this piece of content is inspired by the service manual and typically ought to get your machine functioning, now and again other elements could possibly be in play.

If you are looking at this page and have expertise in this fault and would wish to make a contribution you should leave a comment underneath. Or, if you have read this article and have more questions then ask. If I have knowledge about the issue then I will answer back.

We will be happy to hear your thoughts

Leave a reply

Shopping cart