Canon imageRUNNER 1730 E577 8002 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1730 E577 8002 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1730 E577 8002 Error Code
E577 8002
Description :
Paddle Motor (M3) error
Causes :
The Paddle Motor (M3) was driven for 2 seconds, but the Paddle could not be detected by the Paddle HP Sensor (S3).
Solutions :
1. Check the connector connection of the Paddle HP Sensor (S3) or the Paddle Motor (M3).
2. Check for open circuit of the Harness of the Paddle HP Sensor (S3) or the Paddle Motor (M3).
3. Replace the Paddle HP Sensor (S3).
4. Replace the Paddle Motor (M3).
5. Replace the Finisher Controller PCB.
Always remember, not every error is simply identical. What remedies the condition one occasion may possibly not fix it the next occasion. While the information in this page originates from the service manual and generally should get your unit ready to go, on occasion other things might be in play.
If you are looking at this document and have knowledge of this fault and would like to share please leave a comment underneath. Or, if you have read this article and have more questions then ask. If I have knowledge about the difficulty then I will reply.
