Canon imageRUNNER 1730 E575 8004 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1730 E575 8004 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1730 E575 8004 Error Code
E575 8004
Description :
Gripper Motor (M7) clock error
Causes :
When the Gripper Motor (M7) was operated, the Gripper Encoder Sensor (S8) detected rotation of 400 clocks or more.
Solutions :
1. Check the connector connection of the Gripper Encoder Sensor (S8) or the Gripper Motor (M7).
2. Check for open circuit of the Harness of the Gripper Encoder Sensor (S8) or the Gripper Motor (M7).
3. Replace the Gripper Encoder Sensor (S8).
4. Replace the Gripper Motor (M7).
5. Replace the Finisher Controller PCB.
Always remember, not every error is simply identical. What fixes the difficulty one time may not take care of it the next time. While the ideas in this text is taken from the service manual and most likely ought to get your piece of equipment up and running, from time to time other reasons might be in play.
If you are looking at this document and have knowledge of this error message and desire to make a contribution be sure to leave a comment underneath. Or, if you have read this article and have further questions then ask. If I have exposure to the problem then I will reply.
