Canon imageRUNNER 1730 E537 8001 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1730 E537 8001 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1730 E537 8001 Error Code
E537 8001
Description :
Rear Alignment Motor (M5) error
Causes :
At initialization of the Rear Alignment Plate, the Rear Alignment Plate failed to move from the Rear Alignment Plate HP Sensor (S5) although the Rear Alignment Motor (M5) was driven for 10 mm.
Solutions :
1. Check the connector connection of the Rear Alignment Plate HP Sensor (S5) or the Rear Alignment Motor (M5).
2. Check for open circuit of the Harness of the Rear Alignment Plate HP Sensor (S5) or the Rear Alignment Motor (M5).
3. Replace the Rear Alignment Plate HP Sensor (S5).
4. Replace the Rear Alignment Motor (M5).
5. Replace the Finisher Controller PCB.
Always remember, not every error is simply alike. What fixes the condition one occasion may possibly not resolve it the next occasion. While the details in this writing is inspired by the service manual and most often should get your machine ready to go, now and again other reasons may be in play.
If you are looking at this document and have information about this error message and would wish to share please make sure to leave a comment down the page. Or, if you have read this article and have further questions then ask. If I have exposure to the difficulty then I will respond.
