Canon imageRUNNER 1730 E531 8002 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1730 E531 8002 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1730 E531 8002 Error Code
E531 8002
Description :
Staple Motor (M9) error
Causes :
After execution of staple operation, the motor was operated in the positive direction, but the Staple Unit could not be detected by the Staple HP Sensor (S11) within 0.46 seconds. Then, the motor was rotated in the negative direction, but the Staple Unit could not be detected by the Staple HP Sensor (S11) within 0.46sec.
Solutions :
1. Check the connector connection of the Staple Unit.
2. Disconnect the Harness of the Staple Unit.
3. Replace the Staple Unit.
4. Replace the Finisher Controller PCB.
Always remember, not every error is precisely identical. What treats the malfunction one occasion might not remedy it the next time. While the details in this write-up is taken from the service manual and normally should get your device working, occasionally other causes may be in play.
If you are looking at this document and have information about this error message and would wish to contribute please leave a comment underneath. Or, if you have read this article and have more questions then ask. If I have experience with the trouble then I will answer.
