Canon imageRUNNER 1730 E530 8001 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1730 E530 8001 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1730 E530 8001 Error Code
E530 8001
Description :
Front Alignment Motor (M4) error
Causes :
At initialization of the Front Alignment Plate, the Front Alignment Plate failed to move from the Front Alignment Plate HP Sensor (S4) although the Front Alignment Motor (M4) was driven for 10 mm.
Solutions :
1. Check the connector connection of the Front Alignment Plate HP Sensor (S4) or the Front Alignment Motor (M4).
2. Check for open circuit of the Harness of the Front Alignment Plate HP Sensor (S4) or the Front Alignment Motor (M4).
3. Replace the Front Alignment Plate HP Sensor (S4).
4. Replace the Front Alignment Motor (M4).
5. Replace the Finisher Controller PCB.
Always remember, not every error is precisely identical. What treats the condition one time may possibly not solve it the next occasion. While the advice in this written piece obtain from the service manual and normally ought to get your product up and running, sometimes other reasons may be in play.
If you are looking at this document and have exposure to this malfunction and wish to contribute you should leave a comment below. Or, if you have read this article and have additional questions then ask. If I have knowledge about the trouble then I will respond.
