Canon imageRUNNER 1730 E261 0000 Error Code

 

Canon imageRUNNER 1730 E261 0000 Error Code Instructions

Below you will find the service manual information for the Canon imageRUNNER 1730 E261 0000 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it. 

Canon imageRUNNER 1730 E261 0000 Error Code

Service Manual Instructions for the Canon imageRUNNER 1730 E261 0000 Error Code

E261 0000
Description :
Zero cross signal error

Causes :
When the relay is ON, the zero cross signal failed to be detected for 500 msec or longer.
When the same status was detected again after executing an error retry.

Solutions :
1. Check the connector connection. (All connectors on the DC Controller PCB)
2. Replace the DC Controller PCB (PCB1).




Always remember, not every error is exactly alike. What fixes the problem one occasion may not get rid of it the next occasion. While the data in this short article obtain from the service manual and typically should get your machine up and running, from time to time other factors could possibly be in play.

If you are looking at this document and have experience with this error and would like to contribute be sure to leave a comment underneath. Or, if you have read this article and have additional questions then ask. If I have exposure to the difficulty then I will respond.

We will be happy to hear your thoughts

Leave a reply

Shopping cart