Canon imageRUNNER 1730 E010 0001 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1730 E010 0001 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1730 E010 0001 Error Code
E010 0001
Description :
Main Motor (M2) rotation error
Causes :
Detection was performed every 100 msec since the start of drive and there had been no lock detection signal in 2 seconds.
Solutions :
1. Check the connector between the Main Motor and the DC Controller PCB (J203).
2. Replace the Main Motor (M2).
3. Replace the DC Controller PCB (PCB1).
Always remember, not every error is absolutely identical. What treats the issue one time may not fix it the next time. While the help and advice in this text originates from the service manual and in most cases should get your machine ready to go, sometimes other variables could possibly be in play.
If you are looking at this article and have exposure to this error and want to contribute make sure you leave a comment down below. Or, if you have read this article and have further questions then ask. If I have experience with the situation then I will answer.
