Canon imageRUNNER 1730 E003 0000 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1730 E003 0000 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1730 E003 0000 Error Code
E003 0000
Description :
Detection of fixing low temperature during printing
Causes :
The Main Thermistor detected a temperature lower than 80 deg C for 200 msec or longer on end, or the Sub Thermistor detected a temperature lower than 60 deg C for 200 msec or longer on end.
Solutions :
1. Go through the following to clear the error: CLEAR > ENGIN > ERRCLR in Service Mode; then, turn OFF and then ON the power.
2. Check the connector connection. (J206 on the DC Controller PCB, J101 on the Power Supply PCB)
3. Replace the Fixing Assembly.
4. Replace the DC Controller PCB (PCB1).
Canon FM1-B701-000 Fuser (Fixing) Unit – 110 / 120 Volt (Genuine) – $279.95
from: Precision Roller
Canon imageRUNNER 1730 E000, E001, E002, E003, Error Code Reset
Canon imageRUNNER 1730 Fuser Removal and Replacement
Always remember, not every error is absolutely identical. What fixes the issue one occasion may possibly not solve it the next time. While the guidance in this blog post is taken from the service manual and normally ought to get your machine working, at times other factors may be in play.
If you are looking at this article and have expertise in this error message and wish to make a contribution make sure you leave a comment underneath. Or, if you have read this article and have more questions then ask. If I have knowledge about the trouble then I will reply.
