Canon-imageRUNNER-3570 E248 0000 Error Code Instructions
Below you will find the service manual information for the Canon-imageRUNNER-3570 E248 0000 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon-imageRUNNER-3570 E248 0000 Error Code
E248 0000
Description :
The backup memory is faulty.
Causes :
[Cause] A check error has occurred on the backup SRAM board.
[Location] bottom ROM
[Timing of Detection] once when the boot ROM is started up
Solutions :
1. Check the presence/absence of a backup SRAM PCB.
2. Disconnect and then connect the backup SRAM PCB.
3. Replace the backup SRAM PCB with a new one.
If you’re reading this post and have information about this problem and would like to share make sure you leave a comment underneath. Or, if you have read this article and have further questions then ask. If I have exposure to the situation then I will answer back.
Understand, not every error is absolutely the same. What remedies the malfunction one time might not remedy it the next time. While the data in this article derives from the service manual and in most cases should get your piece of equipment operating, in some cases additional variables might be in play.
