Canon-imageRUNNER-3570 E003 0000 Error Code Instructions
Below you will find the service manual information for the Canon-imageRUNNER-3570 E003 0000 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon-imageRUNNER-3570 E003 0000 Error Code
E003 0000
Description :
The fixing temperature is too low after a standby state.
Causes :
While regular temperature control is under way, the reading of the main thermistor is less than 140 deg C continuously for 400 msec or more.
Solutions :
Reset the condition in service mode: COPIER>FUNCTION>CLEAR>ERR.
Replace the main thermistor.
Replace the DC controller PCB.
Canon FM3-1293-020 Fuser (Fixing) Unit – 120 Volt (Genuine) – $599.95
Canon imageRUNNER 3570 Fuser Removal and Replacement FM3-1278-000, FM2-0356-000
Canon imageRUNNER 3570 E000, E001, E002, E003, Error Code Reset
If you’re reading this piece of content and have exposure to this error and would like to make a contribution please make sure to leave a comment down below. Or, if you have read this article and have additional questions then ask. If I have knowledge about the trouble then I will reply.
Try to remember, not every error is precisely alike. What treats the problem one time may not remedy it the next occasion. While the data in this writing originates from the service manual and typically ought to get your product functioning, now and again other causes might be in play.
