Canon-imageRUNNER-3530 E261 0000 Error Code Instructions
Below you will find the service manual information for the Canon-imageRUNNER-3530 E261 0000 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon-imageRUNNER-3530 E261 0000 Error Code
E261 0000
Description :
The zero-cross signal is faulty.
Causes :
When the relay is on, the zerocross signal is not detected for 500 msec or more.
Solutions :
Replace the AC driver PCB.
Replace the DC controller PCB.
If you’re reading this blog post and have knowledge of this fault and desire to share be sure to leave a comment down below. Or, if you have read this article and have further questions then ask. If I have information about the problem then I will answer.
Take into account, not every error is simply the same. What corrects the complication one time will possibly not remedy it the next time. While the material in this page originates from the service manual and most often should get your piece of equipment working, on occasion other reasons might be in play.
