Canon-imageRUNNER-3530 E248 0000 Error Code

 

Canon-imageRUNNER-3530 E248 0000 Error Code Instructions

Below you will find the service manual information for the Canon-imageRUNNER-3530 E248 0000 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it. 

Canon-imageRUNNER-3530 E248 0000 Error Code

Service Manual Instructions for the Canon-imageRUNNER-3530 E248 0000 Error Code

E248 0000
Description :
The backup memory is faulty.

Causes :
[Cause] A check error has occurred on the backup SRAM board.
[Location] bottom ROM
[Timing of Detection] once when the boot ROM is started up


Solutions :
1. Check the presence/absence of a backup SRAM PCB.
2. Disconnect and then connect the backup SRAM PCB.
3. Replace the backup SRAM PCB with a new one.


If you’re reading this blog post and have knowledge about this error message and would wish to share please make sure to leave a comment down the page. Or, if you have read this article and have additional questions then ask. If I have information about the difficulty then I will answer back.

Take into account, not every error is simply alike. What remedies the condition one time might not solve it the next time. While the ideas in this text is inspired by the service manual and in most cases should get your equipment working, now and again other factors could possibly be in play.

We will be happy to hear your thoughts

Leave a reply

Shopping cart